Revision 19.0
SOLO7 Transmitter Family User Guide
Copyright © 2013 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 7-81
7.1.2
Temperature Control Tips
The SOLO7 Transmitters can get very hot, therefore, it is worth noting some configurations and
environmental conditions that can help mitigate any temperature concerns.
Note
: The FPGA temperature can be monitored as a colour coded scheme on the Domo Device Controller
primary window or from the
Advanced>Unit
tab to monitor the actual temperature in °C of the on-board
FPGA device, see
section 5.4.2.
1.
Use a heatsinking plate, thermal conductivity will help draw heat from the SOLO7 Nano Transmitter
case.
2.
Lower the
Output
power
if operational conditions allow, see
Section 5.5.2.
3.
Switch
Linearity mode
to
Low power
, if operational conditions allow, see
Section 5.5.2.
4.
Change the video encoder format to MPEG4 ASP if operational conditions allow, see
Section 5.7.2.
7.2
Pinout – SOL7NTX
7.2.1
AV Connector – Omnetics Tri-Lobe Latching 9-way Receptacle
7.2.2
Power/Control Connector – Omnetics Nano Circular 6-way Receptacle
