23
FCC/IC/CE COMPLIANCE
Your
SPT 2400 Series
TM
Trainer
has been manufactured under complete
compliance with Part 15 of the Federal Communication Commission (FCC)
rules, Industry Canada (IC) Standard RSS-310, and Article 3 of the
Directive 1999/5/EC. The complex internal structure of each product has
been designed to operate within specific regulations of FCC specifications.
Any changes or modifications not expressly approved by the manufacturer
is a violation of these specifications and could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC rules subject to the following
two conditions:
1. This device may not cause harmful interference
2.
This device must accept all interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This Category II radiocommunication device complies with Industry
Canada Standard RSS-310. 26.96-27.28.10mv.
Ce dispositif de radiocommunication de catégorie II respecte la norme
CNR-310 d'Industrie Canada.
Declaration of Conformity (Directive 1999/5/EC)
D.T. Systems, Inc. declares that the
SPT 2400 Series
TM
products are in
compliance with the essential requirements under Article 3 of the R&TTE
Directive 1999/5/EC by application of the following standards:
Article 3.1(a) - EN 60950-1
Article 3.1(b) - EN 301 489-1 V1.8.1, EN 301 489-3 V1.4.1
Article 3.2 - EN 300 220-1 V2.1.1, EN 300 220-2 V2.1.2
