15
TESTING
To Test the Beeper:
(SPT 2430/2432
only)
A) Press the top button located on the left side of the
transmitter (Locate button). The collar will beep
any time this button is pressed.
B) Press the middle button on the left side of the
transmitter (Run/Point Mode button) to activate the
Run & Point mode. Press the button again to
change to Point Only mode. In the Run & Point
mode, the collar will beep every 4-5 seconds while
shaking the collar unit (simulating a dog on the
run), and every 1-2 seconds when keeping the
collar unit motionless (simulating your dog on
point). In the Point only mode, the collar will beep
only when the collar unit remains motionless.
C) Press the ’Locate’ button to cancel these modes.
NOTE:
If the collar unit is not responding to any signals
from the transmitter, the collar may need to be repro-
grammed to the transmitter (see
page 16
).
To Test the Range:
(
NOTE
: You will need someone to assist you. If you
are testing longer ranges, find a large, safe area with
clear line-of-sight. A 2-way communication device will
help when testing.)
A) Have one person control the Transmitter and other
person hold the collar unit with test light attached.
B) Start moving apart and perform any of the previous
tests in this testing section.
C) Have a way to communicate results during testing.
