SPLINE
®
Technical Manual
53
Cha
ng
in
g a
Sin
gle Sp
ok
e [
M
TB]
V2
01
3.
1
1
_E
N
NOTE
Caution!
Normally, the spoke has to be replaced because it is broken. If the spoke to be replaced is still intact, it
can be cut using a cutter or s.th. similar.
2.
If necessary, cut the spoke:
a) Release the spoke using a screw clamp.
b) Cut the spoke.
c) Take off the screw clamp.
3.
Check if there is a washer (PHR washer) on the
nipple.
4.
Take the spoke with the nipple out of the rim.
If there is a PHR washer: Take care that the washer
does not fall into the rim profile.
Only for spokes in the inner spoke holes of the hub
flange.
5.
Fully loosen the spoke (green) opposite the spoke
head of the spoke (red) that needs to be replaced.
Caution: The figure shows a wheel with bladed spo-
kes.
