S S
Digital witching ystems Australia
S
S
A
D
For Ignition Setting
Problem
Check
No response from
Safe Guard 64
1. Check if the power is good
2. Check if the connections are good
3. Check if the DIP switch setting is correctly set
No output from
Safe Guard 64
1. Check if the connections are good
2. Check if the LED display is correct
3. Check if the fuse is broken (indicated by RED LED next to the
relay)
Daytime Running
Light do not light
up
1. Check if the connections are good
2. Check if the battery voltage is greater than the turn-on threshold
setting when the engine is running in case voltage setting is used
Daytime Running
Light take a long
time to switch off
1. Change to use the Ignition Switch setting
Combo 64
Combo 64
1. Disconnect Battery before doing any connection.
2. Connect Ignition Switch to the Combo 64 Ignition Switch input respectively.
3. Connect Daytime Running Light to Combo 64 Daytime Running Light Output.
4. Ensure the polarity Ignition Switch, and set the DIP switch setting accordingly.
5. Connect the Battery to Combo 64.
6. Switch OFF BOTH Park Light/Ignition Switch, Daytime Running Light should turn OFF.
7. Switch ON Ignition Switch, Daytime Running Light should turn ON after 5 seconds.
8. Switch OFF Ignition Switch, Daytime Running Light should turn OFF after 20 Seconds.
9. Switch ON Ignition Switch again, Daytime Running Light should turn ON after 5 seconds.
10. Switch ON Park Light, Daytime Running Light should turn OFF immediately.
11. Switch OFF Park Light, Daytime Running Light should turn ON after 5 seconds.
Input Connector Phoenix Connector 1 x 6 Pin
Output Connector Phoenix Connector 2 x 6 Pin
Operating Temperature - 20 C to 85 C
Storage Temperature - 40 C to 85 C
Dimensions (mm) 111.5(L) x 90.5(W) x 32(D)
Mechanical Parameters
Trouble Shooting
