DSP PWR-DSP3, User Manual, Page: 23 / 27

PWR-DSP3
User Manual
Page 23 of 27
Copyrights DSP4YOU ltd
5 Technical specifications
5.1 Electrical specifications
Item Description
Network Processor Plug&Play network processor for remote Amplifier/ DSP control over Ethernet networks.
Support of DHCP, Auto IP and mDNS for automatic addressing.
Digital Signal Processor On board DSP for gain, parametric equalizer, matrix mixing, phase, compressor limiter,
delay, RMS meters
Balanced audio input Two analog balanced audio inputs on Neutrik XLR connectors
Max input selectable by jumper setting: 8Vrms (20dBu) or 2Vrms (8dBu)
Audio over Ethernet (optional) Audio Video Bridging (AVB) for streaming of low latency, un-compressed audio over
Ethernet networks
Supports IEEE standards: 802.1as, 802.1Qat, P1722
Audio streaming capability: up to 3 input streams and up to 3 output streams (link out over
AVB)
Power ratings (RMS @ 1% THD) Channel 1: 800W @16Ω, 1550W @8Ω, 2400W @4Ω, 4000W Peak
Channel 2: 200W @16Ω, 400W @ 8Ω, 700W @4Ω, 1400W Peak
Channel 3: 200W @16Ω, 400W @ 8Ω, 700W @4Ω, 1400W Peak
Amplifier module specifications SNR: > 120 dB (A-weighted, 20 Hz - 20 kHz, 8 Ω load)
THD (typical): < 0,05 % (20 Hz - 20 kHz, 8 Ω load, 3 dB below rated power)
Frequency response: 20Hz - 20kHz +/- 0.15dB (8 Ω load, 1 dB below rated power)
Damping factor > 1000 (8 Ω load, 1 kHz and below)
Audio source selection Selectable by software/ hardware between analog source (up to 2 inputs) and network
(AVB) source (up to 3 inputs)
Protection circuits Input limiter, short circuit protection, DC protection of output, under & over voltage
protection,
intelligent mains fuse protection, power stage overload protection, temperature protection of
transformers and heat-sinks
Real time readouts from interface Clip, Protect mode, Output voltage, Output current, Heatsink temperature
Front Panel LED Power, Thermal, Network activity, Clip LED for channels 1 to 3
Front Panel controls Rotary volume control (0-100%)
Amplifier audio source selection (Network or Analog)
Front panel connectors Two Ethercon Neutrik connector for network connectivity (RJ45 compatible)
Thwo Neutrik XLR female connectors for analog inputs
One Powercon Neutrik connector for Main AC in
One Powercon Neutrik connector for Main link out
Universal Mains power 95 ~ 240VAC
Weight 6 kg
Dimensions (H x W x D) mm 490 x 170 x 138.5 mm (19.3” x 6.7” x 5.5”)