S-28
24: Servo Speed
To Adjust Servo Speed
The 12X provides the ability to adjust the speed of servos for
each channel in each direction. The speed may be reduced
(servo slowed) from its normal speed but it cannot cause a
servo to move faster than its rated specifications. Each servo
can have 2 sets of speeds in each direction that are Flight Mode
or switch selectable.
1. Highlight and select SRV. Speed. Speed FUNC.LIST.
2. If flight modes are not programmed, select SW SEL and
press the roller to access Switch Select. If only one servo
speed is desired, then all selectable switch positions in this
screen should be P0. If two servo speeds are desired, then
assign the desired switch that will change the servo speed
to P1. Return to the main screen.
3. If a single set of servo speeds is desired, make sure the
display is showing Pos0. If it is not, select Pos1 and
change it to Pos0. Highlight and select the channel and
direction for each servo that is to be adjusted. Once a
direction for a servo is selected, the servo speed may be set
so the servo travels from .193 seconds for 60 degrees of
rotation to 16.4 seconds for 60 degrees of rotation. Adjust
the speed of each servo until the desired speed is obtained.
4. If 2 sets of servo speeds are desired that are Flight Mode or
switch selectable, one set of values is set to NORM for all
channels; slowing of servos can be turned off by selecting
the position (Pos0 or Pos1) that has the NORM values.
Highlight and select Pos0 and change it to Pos1 and then
highlight and select the channel and direction for each
servo that is to be adjusted. Once a direction for a servo is
selected, the servo speed may be set so the servo travels at
the desired slower rate. Switch between Pos0 and Pos1 to
view and adjust the 2 sets of values for each servo.
Note
: Pos1 always has priority over Pos0. In other words,
if multiple switches are selected and one of the switches
is in its Pos1 position, then all other switches are ignored
and the Pos1 values are in effect.
5. If flight modes are programmed, using the roller highlight
the flight mode then press the roller. Rotate the roller to
access the desired flight mode then select the servo speed
desired for that flight mode. Repeat for all flight modes.
Summary of Contents for JR 12X
Page 191: ...W 5...