Operation
Part No. 057-129 DSE871x mono remote display ISSUE 2.1 21/09/2010 ADM
43
5.5.3 ENGINE RUNNING
In manual mode, the load is not transferred to the generator unless a ‘loading request’ is made.
A loading request can come from a number of sources.
•
Pressing the transfer to generator
button.
•
Request from DSE8760 mains controller or from another DSE8710 controller over the MSC link.
•
Activation of an auxiliary input that has been configured to remote start on load
•
Activation of the inbuilt exercise scheduler if configured for ‘on load’ runs.
NOTE:-The load transfer signal remains inactive until the Oil Pressure has risen. This prevents
excessive wear on the engine.
If the common bus is measured to be ‘dead bus’, the load breaker is closed.
If the bus is measured to be ‘live bus’, synchronising takes place before the breaker is closed.
Once the load has been transferred to the generator, the load switch will not be automatically opened unless:
•
Press the Open Generator button (DSE8710 only)
•
Press the auto mode
button to return to automatic mode.
5.5.4 MANUAL FUEL PUMP CONTROL
•
Navigate to the instruments page using the
buttons and locate FUEL LEVEL.
is shown on the
module display to indicate that this feature is available.
•
Press and hold the
button to energise the transfer pump. The pump starts two seconds after the button
is pressed.
•
Release the
button to de-energise the transfer pump.
5.5.5 MANUAL SPEED CONTROL
•
Navigate to the instruments page using the
buttons and locate ENGINE SPEED.
is shown on the
module display to indicate that this feature is available.
•
Press the
button to enter edit mode
•
Press
(up or down) to change the engine speed.
•
Press the
button again to exit the editor and leave the engine running at the newly selected speed.
CALL US TODAY
1-888-POWER-58
REQUEST A QUOTE
SHOP ONLINE
www.genpowerusa.com
