DSE DSE8661, Operator'S Manual, Page: 109 / 120

Front Panel Configuration
109
8.2 ‘RUNNING’ CONFIGURATION EDITOR
8.2.1 ACESSING THE ‘RUNNING’ CONFIGURATION EDITOR
•
The ‘running’ editor can be entered whilst the generator bus is on load. All protections remain
active if the generator bus is available and on load while the running editor is entered
• Press and hold the Tick button to enter the ‘running’ configuration editor.
8.2.2 ENTERING PIN
NOTE: The PIN is not set by DSE when the module leaves the factory. If the module has a
PIN code set, this has been affected by the panel supplier who should be contacted if the
code is required. If the code has been ‘lost’ or ‘forgotten’, the module must be returned to
the DSE factory to have the module’s code removed. A charge is made for this procedure.
NB - This procedure cannot be performed away from the DSE factory.
NOTE: The PIN is automatically reset when the editor is exited (manually or
automatically) to ensure security.
•
Even if a module security PIN has been set, the PIN is not requested whilst entering the ‘running’
editor.
8.2.3 EDITING A PARAMETER
NOTE: Pressing and holding the Instrumentation Scroll buttons gives an auto-
repeat functionality. Values can be changed quickly by holding the navigation buttons for a
prolonged period of time.
•
Press the Instrumentation Scroll buttons to cycle to the parameter to be edited.
• Press the Tick button to edit the parameter. The parameter begins to flash to indicate
that the parameter is being edited.
•
Press the Instrumentation Scroll buttons to adjust the parameter to the required value.
• Press the Tick button to stop editing the paramter. The parameter ceases flashing to
indicate that it the parameter is no longer being edited.