3
Section 2: Getting
Started
2.1 Installation Steps
Follow these steps to install the PC5936 audio interface module
and audio stations. Review this section to get an overall under-
standing of the order of installation. Once this is done, carefully
work through each step.
Step 1
Mounting the PC5936 Audio Interface Module
Mount the cabinet close to the control panel as the PC5936 must
be connected to the incoming telephone line. Before attaching the
cabinet to the wall make sure to press the nylon circuit board
mounting studs into the cabinet from the back.
Step 2
Connecting the PC5937 Module (optional)
To add 8 ports to the system, connect the PC5937 to the PC5936
module. See the PC5937 Installation Sheet for instructions.
Step 3
Wiring the Keybus
Wire the Keybus to the PC5936 audio interface module according
to the diagram provided in 2.2 “Keybus Wiring” on page 4.
Step 4
Wiring the Audio Stations
Wire each audio station according to the diagram provided in 2.4
“Audio Station Wiring” on page 5.
Step 5
Wiring the Incoming Telephone Line
Wire the incoming telephone line according to the diagram pro-
vided in 2.5 “Telephone Line Connection” on page 6.
Step 6
Supervision of the PC5936
The PC5936 will function upon power-up; however, full supervi-
sion of the module must be enabled in the panel (PC5020/P-8+).
Step 7
Program the Panel
The PC5936 audio interface module programming can be done
from any PowerSeries keypad. Refer to the Audio Interface Pro-
gramming Worksheets for program items and options.
Helpful Installation Tips
Feedback
If an intercom station appears to be exhibiting feedback noise,
check the following for potential causes.
• Microphone - Remove the backplate. The microphone and
holder are located in the bottom-left corner. Ensure that the
microphone is pushed fully into the black rubber holder so that
the face of it is flat against the rubber.
• Speaker - Ensure that the felt is secured around the speaker.