5
Enroll Wireless keys
1. At a system keypad, enter [
✱
][8][Installer’s code] to go to the Installer’s
programming section.
2. Enter programming section [804].
3. Enter a 2-digit number [41]-[56] to assign the wireless key a slot. These
numbers correspond to wireless key numbers 01-16.
4. Enter the key’s ESN. The entry
must be 6 digits. If an older key with a 5-
digit ESN is being enrolled, add the digit [0] to the beginning of the ESN.
(E.g. ESN=61234, enter 061234)
5. The key is now enrolled on the system. Record the serial number and the
assigned slot number in the programming worksheets in the back of this
manual.
6. Repeat steps 3 - 5 until all wireless keys have been enrolled.
7. (PC5015 only)
(PC5015 only)
(PC5015 only)
(PC5015 only)
(PC5015 only) By default, all wireless keys are assigned to Partition 1. To
assign keys to Partition 2, enable the appropriate options in programming
sections [91] and [92].
NOTE
: A wireless key can only be assigned to one partition.
8. To exit press [#].
Program the WLS909-433 and WLS919-433 Function Buttons
Wireless keys have four programmable function buttons. You must program a
set of four functions for the buttons before any keys will work. After the functions
are programmed, when you press and hold one of the four buttons for two
seconds, the system will execute the programmed function.
For systems not using partitions:
program the function buttons in section [59].
All wireless keys will have the same four functions.
For systems using 2 partitions (PC5015 only):
all wireless keys assigned to
Partition 1 will have the four functions programmed in section [59]. All wireless
keys assigned to Partition 2 will have the four functions programmed in section
[60]. For example, if function button 1 in Section [59] is programmed for Stay
arming, then pressing the first button on wireless keys assigned to Partition 1 will
Stay arm Partition 1.
NOTE
: Wireless keys will not work when the partition they are assigned to is
being accessed for zone bypassing or programming.
1. At a system keypad, enter [
✱
][8][Installer’s code].
2. Enter programming section [804].
3. Enter programming section [59] for keys assigned to partition 1, or [60]
for keys assigned to partition 2.
4. For each of the 4 function buttons, enter the 2-digit number of the function
you want to select. See the programming worksheets for a list of function
key options.
5. Record your programming choices in the worksheets in the back of the
manual.
6. To exit press [#].
W I R E L E S S D E V I C E S