11
7. Go to the next device to be tested and activate it until the test result is
displayed/sounded.
NOTE
: Wait until the placement test of one device is shown/sounded before
beginning to test the next device.
Continue to test the devices until both the PC5132 and the devices are in
good locations. If several wireless devices produce BAD test results, you
may need to move the PC5132 to a better location. (See section 2.2 for
tips on finding a location for the PC5132.)
8. To exit the placement test and return to installer programming, press [#]
twice.
Testing Individual Wireless Devices:
1. Temporarily place the WLS904-433,WLS906-433, WLS907-433 or
WLS925L-433 you want to test in the place you want to mount it.
2. At a system keypad, enter [
✱
][8][Installer Code].
3. Enter programming section [904].
4
Enter the 2-digit zone number for the device to be tested.
5. Activate the device being tested until a result is displayed on the keypad
or sounded by the keypad or bell. (Same as step 5 in the Global
Placement Test section, previous page.)
6. To test another device, press [#] once, then repeat steps 4 - 5. Continue
to test the devices until both the PC5132 and the devices are in good
locations.
If several wireless devices produce BAD test results, you may need to
move the PC5132 to a better location. (See section 2.2 for tips on finding
a location for the PC5132.)
7. To exit the placement test and installer programming, press [#] twice.
Testing Individual Wireless Keys:
You cannot use the individual device test described above to test WLS909-433
wireless keys. To ensure that the PC5132 receiver is receiving transmissions
from the devices, use the function keys on the WLS909-433 at several different
points in the installation.
5.2 Mount the PC5132 and Wireless Devices
When you have tested reception of the PC5132 with all the wireless devices (see
section 5.1) and you have a good mounting location, mount the PC5132:
1. Pull the Keybus wires through the hole at the bottom of the cabinet.
2. Mount the cabinet securely to the wall.
Mount the Devices
If you have conducted the placement test described in section 5.1 and got 3
“Good” or “Fair” results in a row for each device, you can mount the wireless
devices. See the Installation sheet for each device for mounting instructions.
Now that your PC5132 and wireless devices are mounted and working properly,
read section 6 for information on potential wireless trouble conditions, RF
jamming signals, and battery replacement.
T E S T I N G & M O U N T I N G