24
During walk test mode, no alarms in that area will be transmitted to the central
station. However, if a printer is connected to the system, the open zones will be
printed.
•
Start Local+Com Walk Test?
:
This option operates the same as Local Walk
Test, except that alarms will be transmitted to the central station in order to test
communications.
•
Start Silent Com Walk Test?
:
This option will operate the same as the
Local+Com Walk Test, except that the bell will not sound when each zone is activated.
•
Start Seismic Test?
:
This option will test all seismic detectors enrolled on the
system. The test will perform itself and will take a few minutes to complete. Once
the test is finished, the area will return to its normal disarmed state.
•
End Walk Test?
:
To end every walk test, this option must be selected. Once you
have completed your test, enter the [Walk Test Code]. Select the area that was
tested, and then use the arrow keys to scroll to this option and press
.
The system will turn off walk testing for the area. The walk test mode will also be
automatically turned off if the area is armed.
4. When you are finished walk testing the system, select the
End Walk Test
menu
option. If any part of your system did not work correctly during the walk test, contact
your installation company immediately.
8.2 Allowing System Service ________________________________________________________
Your installer may have set up the system so that a master user will need to allow system
service before a service technician can access the system programming (either at a keypad,
or from a remote computer).
To allow a service technician to have access to the system programming, answer
to:
Allow System
Service?
The service technician will now be able to access system programming for the next 60
minutes.