4
Assembly
1. Unpack the product. Check the contents against the scope
of supply (see section entitled "Scope of Supply") to ensure
they are complete and have not been damaged during trans-
portation. If you
fi
nd any transport damage, do not use the
product (!), but contact the customer service department.
2. Screw the castors (K + L) onto the base (D).
3. Use the spanner (S) to do this.
4. Screw the lower part of the table leg (E) onto the base (D)
using the long screws (R) and nuts (N).
5. Use the Allen key (T) and the spanner (S) to do this. Make
sure that the hole in the lower part of the table legs faces in
the right direction (see arrow).
6. Pull the cover (U) over the lower part of the table leg (E) and
slide it all the way down to the bottom.
7.
Screw the cross
struts onto the up-
per part of the table
leg (C) using the ex-
tra long screws (O)
and nuts (N).
Use the Allen key (T)
and the spanner (S)
to do this.
8. Attach the upper part
of the table leg (C)
to the bottom of the
large tabletop (A)
with the mounting
bracket (H) and two
short screws (M). To
do this, use the Allen
key (T).
9. Attach the hinge (G)
on the upper part of
the table leg (C) with
the locking screw for
setting the angle (I)
and the washers (Q).
Then screw the hin-
ge using two short
screws (M) onto the
large tabletop (A). To
do this, use the Allen
key (T).
10.
Screw the cross
struts (F) onto the
small tabletop (B)
with the medium
screws (P). To do
this, use the Allen
key (T).
11. Place the upper part
of the table leg (C)
into the lower part of
the table leg (E) and
connect the two parts
together at the height
you want using the
locking screw for set-
ting the height (J).
• The height of the table leg can be adjusted. To adjust it undo
the locking screw for setting the height (J), set the height you
want (pull the parts of the table leg apart or push them to-
gether) and then tighten the locking screw again. Make sure
that the holes in the lower part of the table leg (E) and in the
upper part of the table leg (C) overlap.
• To lock the base in place, push down the levers on the locka-
ble castors (K).
• The large tabletop (A) is tiltable. To adjust it, release the lo-
cking screw for setting the angle (I) (do not undo it comple-
tely!), set the tilt angle you want and then tighten the locking
screw again.
Disposal
The packaging can be recycled. Please dispose of it
in an environmentally friendly manner and take it to a
recycling centre. Dispose of the product in an environ-
mentally friendly manner as well. You can obtain more
information from your local authorities.
Customer Service Department / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 38851 314650 *)
*) Calls subject to a charge.
All rights reserved.
