![background image](http://html.mh-extra.com/html/ds-produkte/01784/01784_instruction-manual_2533911017.webp)
17
EN
4. Insert the cleaning foot (
9
) into the main unit (
6
) until you hear the cleaning foot en-
gage. To detach the cleaning foot (
10
), press the release button (
13
) on the back of
the main unit (
6
) and pull it off at the same time.
Filling the Water Reservoir
CAUTION!
■
The water reservoir cannot be removed! To
fi
ll the water reservoir, use the measuring
cup that is also supplied!
■
Do not over
fi
ll the water reservoir,
fi
ll it no higher than the
MAX
marking.
■
Never operate the device without water. If it is used for a prolonged period, top it up
again promptly.
We recommend that you pour cold distilled water into the water reservoir (
8
) in
order to prevent calci
fi
cation, particularly if the tap water is very hard.
1. Open the water reservoir cap (
8
).
2. Tilt the main unit (
6
) back slightly to make it easier to pour in
the water.
3. Use the measuring cup that is also supplied to pour cold, clean
water into the water reservoir (
9
) (note the
MAX
marking).
4. Close the water reservoir cap (
8
).
Use
CAUTION!
■
Use the device only if it has been fully and correctly assembled and the
fl
oor cloth has
been attached for cleaning
fl
oors.
■
Beware of the risk of scalding!
After you switch off the device, hot steam may
continue to emerge for a few seconds! Even after cooling, the water in the reservoir
still remains hot!
We recommend that, before using the device, you sweep the
fl
oor with a broom
or vacuum it using a vacuum cleaner.
1. Pull the
fl
oor cloth (
12
) over the cleaning foot (
10
) and pull the draw cord tight so that
it cannot slip off.
Use the carpet glider (
11
) that is also supplied to clean carpets. To do this,
place the carpet glider (
11
)
fl
at on the carpet to be cleaned and place the
cleaning foot (
10
) with the
fl
oor cloth (
12
) on the carpet glider (
11
).
2. Stand the device upright. The joint of the cleaning foot (
10
) locks in place in a vertical
position.
3. Insert the mains plug into a properly installed plug socket that is easily accessible.