![background image](http://html.mh-extra.com/html/ds-produkte/00519/00519_instruction-manual_2533556021.webp)
21
EN
•
Wide-apart buttons
may result in the
button strip crimping
slightly during pressing.
Here it is advisable to smooth down the button strip again by hand immediately after
the pressing process.
• In the case of trousers with a very small waist it may not be possible to pull them over
the attachment when it has already been
fi
tted. In this case you proceed as follows:
–
push the nylon balloon (
12
) upwards slightly, to enable access to the rods (
13
),
–
remove one of the two rods from the Y tube once more (
11
),
–
draw the trousers over the two rods,
–
now replace the rods in the Y tube and
–
draw the nylon balloon over the mounting
fl
ange on the main device again.
• After the drying / pressing process any creases need to be ironed out using a normal
iron.
Cleaning and Storage
PLEASE NOTE!
■
Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the
device. These can damage the surface.
• Clean the device and the nylon balloons if necessary with a slightly damp cloth and a
little mild detergent if required. Then wipe down fully with a dry cloth.
• Allow all parts to dry completely before you put them away.
• Store the device in a clean, dry place that is protected from sunlight and is not acces-
sible to children and animals.
Troubleshooting
If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective
electrical device yourself!
Problem
Possible cause / solution
The device does not
work. The LEDs do
not light up.
• Is the mains plug inserted in the plug socket correctly? Cor-
rect the
fi
t of the mains plug.
• Is the plug socket defective? Try another plug socket.
• Check the fuse of the mains connection.
• Is the device switched on? Set the timer (
7
) to a time.
Unusual noises
• Are the ventilation slots (
6
) covered up or blocked? Free up
the ventilation slots.