DryTek Vigor 2952 series, User Manual

Page: 695 / 811

Vigor2952 Series User’s Guide 683
<sec>: Type a number to set the UDP session timeout.
-i <sec> It means “IGMP” protocol.
<sec>: Type a number to set the IGMP session timeout.
-w <sec> It means “TCP WWW” protocol.
<sec>: Type a number to set the TCP WWW session timeout.
-s <sec> It means “TCP SYN” protocol.
<sec>: Type a number to set the TCP SYN session timeout.
-f It means to flush all portmaps (useful for diagnostics).
-l <List> List all settings.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> portmaptime -t 86400 -u 300 -i 10
> portmaptime -l
------ Current setting ------
TCP Timeout : 86400 sec.
UDP Timeout : 300 sec.
IGMP Timeout : 10 sec.
TCP WWW Timeout: 60 sec.
TCP SYN Timeout: 60 sec.
T T e e l l n n e e t t C C o o m m m m a a n n d d : : p p p p a a
S
S
y
y
n
n
t
t
a
a
x
x
ppa [-<command> <parameter> | ... ]
ppa n [-<command> <parameter> | ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
[<command>
<parameter>|…] The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-m <mode> Specify a mode.
1=auto
2=manual(traffic)
3=manual(qos)
4=manual(specific hosts)
0=disable
-p <proto> Specify a protocol.
proto - 1-TCP; 2-UDP; and 3-Both.
-b 1/0 Enable/disable TWO-way hardware acceleration.
-M enable/disable Enable/disable the multicast hardware acceleration.
-v Show PPA_WAN_Table and PPA_LAN_Table for reference.
-c Clean all settings.
ppa n – used in QoS or specific host
-l <rule> Specify an index number of rule profile for QoS mode.
-h <host> Type an IP address for Specific Host mode.
-s <start port> Specify a starting port number for Specific Host mode.