21
5.
Square your mounting board with the tacked print against the edge of the Leader Board
and drape the print over the top roller.
6.
Run the mounting board/adhesive/image through the rollers while simultaneously pulling
the release liner away from and off of the board.
(JM44 and JM54 models have automatic Take Up shafts on the front of the chassis. You
may choose to unwind the Release Liner onto the Take Up shaft during this process, rather
than pulling it by hand. See page 17 for information on setting the Take Up Shaft tension).
L
a
m
inating with
Jet
Mounter
™
Laminators
Selecting a Laminating Film
Select an appropriate overlaminating film for the surface of your image based on aesthetics
and the conditions under which it will be displayed. Drytac offers a wide variety of films to
match your specific output and application. Please consult your Drytac catalog for
descriptions of available film choices.
There are several types of laminating jobs that can be performed on
Jet
Mounter
™
laminators. The following are the most common applications. To prevent adhesives from
sticking to the rollers and to provide a reusable, standard working surface, the use of a
silicone-
coated board (also known as a “Carrier Board”) is highly recommended. (See page
26 for instructions).
