12
It is recommended that the machine be placed so that at least three feet of space from the
front and back
beyond
the largest piece of material you will use be provided to insure
adequate accessibility and safety. For example, if your work piece were a four-foot by eight-
foot foam board, you would need to allow a
minimum
of eleven feet of space in front and
eleven feet of space in the rear of your machine. Always consider this rule a necessity prior
to beginning your work. (Converted figures in the illustration below in metric are 3 meters
and .6 meter).
Jet
Mounter
™
Components
1. The main
On-Off
switch is a rocker switch located on the back of the machine near the
power cord entry
. This switch should be in the “OFF” position when loading or unloading
adhesives or film, cleaning the rollers or performing other activities that require close
proximity of your fingers to the Nip.
2.
The
Auto/Foot/Reset
switch. This two-position rocker switch on the front control panel
is used to choose the mode of operation between “Foot” and “Auto”. The photocell
safety feature functions differently in each position. It is important to review the safety
information prior to selecting the mode of operation. This switch also serves as a
Reset
.
Upon powering up the machine, when the photocell is tripped or one of the
Emergency
Stops
has been
activated, you must toggle the switch before proceeding. Be sure to
first remove the obstruction, reposition the emergency stop or correct the cause for the
shut down in order to effectively
Reset
the machine. If the shut down was caused by a
thermal overload condition, you must first allow the circuit breaker on the back of the
machine to cool (approximately 20-30 seconds), then reset the breaker and then reset
the machine by toggling the
Auto/Foot/Reset
switch.
