26
Instructions for use BELLAVITA
Drive Medical GmbH & Co. KG | As per: 06.10.2020 | Errors and alterations excepted
EN
1. Insert the jack of the power supply unit into the jack
socket on the spiral cable of the manual control until
the jack clicks into place.
2. Plug the power supply unit into an outlet.
3. The red indicator light on the manual control is lit red
until the battery is charged. Then it is lit and green.
If the battery is to be fully charged, leave the battery
connected to the power supply unit. The control sys-
tem of the power supply unit ends the charging pro-
cess after approx. 4 hours. This avoids overcharging
the battery.
4. Unplug the power supply unit from the outlet.
5. Pull the jack of the power supply unit out of the jack
socket on the manual control.
Important information:
If the charging indicator does not light
up after connecting the manual con
trol, check the following points:
• Quality of the connections (jack fully inserted into
the charging socket).
• Check manual control, spiral cable with jack
socket, and charging cable for damage.
Note:
If the power supply unit is damaged, return it to the
supplier for inspection.
Transport / Mobile use
In the case of
mobile use
, the following should additionally
be borne in mind:
1. The manual control on the bath lift must be unplugged
and transported separately.
2. During transport (for example, in a vehicle), always
secure the bath lift against slipping.
3. If the battery integrated in the manual control is ex-
posed to low temperatures (such as in the winter
during storage in a vehicle), allow the battery to warm
up to room temperature and charge, if necessary.
4. Be aware of product weights when lifting: the seat
unit weighs approx. 5.5 kg and the drive unit (without
manual control) weighs approx. 3.8 kg.
Transport as separate sections
The seat and drive unit can be easily carried by the two
hand grips.
27
Transport in a locked condition
The bath lift can also be transported as a complete unit.
28
