24
Instructions for use BELLAVITA
Drive Medical GmbH & Co. KG | As per: 06.10.2020 | Errors and alterations excepted
EN
Taking the lift out of the bathtub
First use the manual control to lower the bath lift all the
way and allow the backrest to pivot all the way back un-
til the power unit stops by itself in its end position
(pho
to 21)
. In doing so, ensure that the backrest does not hit
the wall of the tub. Then unplug the manual control.
1. Fold the side flaps on the seat surface inwards.
2. Fold the backrest forwards. To hold the lift, use the
hand grips on the drive unit.
21
3. You must ensure that the lifting rod is always fully re-
tracted
(photo 23)
.
22
Incorrect
23
Correct
2. The drive unit can now be removed from the seat
frame in the direction of the arrow.
Note: The drive unit can be removed only at a particular
angle. It can therefore no longer be removed from the
seat unit when it is folded completely forward since it
is then locked into place again. Bring the backrest into
the angle as shown in photo 24 and then remove the
drive unit from the seat frame in the direction of the
arrow.
4. Release both rear suction cups on the base plate by
pulling the tabs. Then lift the base plate backwards
which will cause the front suction cups to automatical-
ly vent and release. Now take the seat unit out of the
bathtub.
24
Maintenance and care
Maintenance of the bath lift
The bath lift is equipped with maintenance-free bear-
ings and bearing surfaces. Therefore no lubrication is re-
quired.
The entire bath lift should be periodically inspected (vi
sual inspection by the user) at least every 6 months.
This includes a visual inspection in particular of the
load-bearing parts and the safety features, as well as all
necessary function testing.
