DRI-STEEM Ultra-sorb Steam Dispersion Panel Installation, Operation, and Maintenance Manual • Page 5
F i e l d a s s e m b l y o f M o d e l L H
OM-238-3
STEP 2 - Bolt the mounting flanges to the supply header
assembly
Refer to Figure 5-1 and 5-2.
Attach the two mounting flanges to the supply header assembly as
indicated using ¼" - 20 bolts with the nuts finger tight.
STEP 3 - Insert the dispersion tubes
Refer to Figure 5-3. Insert the plain ends (no slip couplings)
of the dispersion tubes into the slip couplings already mounted
on the supply header assembly. The slip couplings are factory
lubricated; if well aligned during insertion, no further lubrication
should be needed. Push and twist the tube in until it bottoms out
on the internal shoulder of the slip coupling (see Figure 5-4).
C A U T I O N !
Use care to avoid cutting the internal O-rings of the
slip couplings.
Dispersion tube
Supply header
assembly
Slip coupling with shoulder
OM-238-6
Shoulder
O-rings
OM-239
¼" - 20 bolts
Mounting flange
OM-238-7
O-rings
Figure 5-1:
Supply header assembly
Figure 5-2:
Detail view of mounting flange
Figure 5-3:
Dispersion tubes
Figure 5-4:
Slip coupling with shoulder
Figure 5-5:
Slip coupling without shoulder
OM-238-2
Drain connection
Washer and nut
Steam inlet
Supply header assembly
¼" - 20 bolt
Washer and nut
¼" - 20 bolt
Mounting flange
Steam
inlet
US-IOM-0108.pdf 5
4/21/2010 11:34:57 AM
