Drija OCEANIA 60, User Manual

Page: 5 / 17

User Manual
HORNO A GAS |
OCEANÍA 60
5

Gas or electrical appliances should always be disconnected by persons with
adequate capacities.

The plug to connect to the power supply cable and the relative plug must be
of the same type and comply with the relevant regulations.

The plug of the power supply must be accessible even after the appliance
has been built.

Never disconnect the plug taking advantage of the power supply.

The appliance must be connected to the ground in accordance with the safety
regulations of the electrical system. Immediately after installation, perform a
quick test on the device following the instructions provided after this manual.
If the appliance can not work, disconnect the power supply and contact your
nearest service center.

Never attempt to repair the appliance.

Never place flammable objects in the oven: if it should be ignited accidentally,
this may cause a fire.

The appliance becomes very hot during use. Be careful never to touch the
heating elements inside the oven.

The device is designed for adult use. Keep children at a safe distance and
never allow them to play with him.

When the grill is in operation, accessible parts can be very hot: keep children
at a safe distance. Before putting the appliance into operation, all protective
labels and films applied inside or outside must be removed.

After each use, always check that the control knobs are turned to 0 (off)
The manufacturer declines all responsibility for injuries or damages caused by
non-compliance with the previous standards or for manipulating even a single
part of the application and the use of non-original spare parts.
4. INSTALLATION INSTRUCTIONS
Electrical connection: The nameplate should never be removed. The device must
be connected to earth in accordance with the safety regulations of the electrical
system.
If a permanent connection is used, the power supply line of the device must be
equipped with an omnipolar break device with a contact space of at least 3 mm,
located in an easily accessible position near the device itself.