© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
QUATRA LUX 32x46 34x46 shower enclosure manual Ver 3 Rev 4a 112019
13
©2019 DreamLine. All Rights Reserved
!
NOTICE:
Make sure the
Bottom Sweep Vinyl
is flush with the vertical edge of the
Handle
side of the
Door Glass (#02).
2
3
4
5
6
1
door
door
door
2
3
4
1
Fig 10
Fig 11
door
inside
hinge
panel
+/-
10.
Measure the bottom of the
Door Glass (#02)
from end to end to determine the actual width. Using
a razor knife, cut the
Bottom Sweep Vinyl (#13)
to the ewidth of the door glass. Optional: close the
door and mark the sweep where it overlaps the strike vinyl; then notch approximately 3/8” off of the
inner side of the
Bottom Sweep Vinyl
as shown in
Fig. 16.2
. Press the
Bottom Sweep Vinyl
tightly
onto the bottom edge of the
Door Glass (#02).
(Fig 10)
11.
Take three measurements to prepare to notch the
Hinge Side Vinyl (#12)
to fit around the hinges:
• from the top edge of the
Door Glass (#02)
to the upper body
of the top
Hinge (#06)
(+) 7/8”
• from the lower body of the upper
Hinge (#06)
to the upper body
of the bottom
Hinge (#06)
(+) 1-3/4”
• from the lower body of the bottom
Hinge (#06)
to top
of the installed
Bottom Sweep Vinyl (#13)
(+) 1-7/8”
Cut the
Hinge Side Vinyl (#12)
according to the measurements.
Notch the cut strips to be able to slide them into the
Hinge (#06)
and around the sweep vinyl to cover
the space to the inline panel glass. Press the cut strips onto the vertical edge of the
Door Glass (#02)
.
(Fig 11)
