© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
Installation Steps for Support Bar
QUATRA LUX 32x46 34x46 shower enclosure manual Ver 3 Rev 4a 112019
10
©2019 DreamLine. All Rights Reserved
TIP:
Attach the
90º Strike
Vinyl
(#11)
to the edge of
the return panel glass to
protect the edge during the
installation of the door glass.
NOTE:
Make sure to use clear rubber
gaskets to prevent glass to metal
contact.
Fig 7
Fig 6
23-7/8”
23-7/8”
return
panel
outside
Ø5/16
”
7
1
2
3
4
5
6
6.
Locate the
Support Bars (#04).
Position the support bar brackets on the panel glass and the wall (at a
45° angle
if possible) and level it
horizontally. Hold the bracket firmly to the wall and outline the bracket’s position on the wall (Fig. 6.1).
Remove the
Support Bar (#04)
and detach the wall bracket. Place the wall bracket against its outlined
position on the wall and mark the drilling hole.
Drill the hole using a
Ø5/16”
drill bit, insert the
Wall Anchor (#07)
and fasten the wall bracket to the
wall with the
Countersunk Screw ST4.2×40 (#17).
Attach the
Support Bar (#04)
to the wall bracket as
shown in
Fig. 6.5.
Use the supplied gasket to protect the glass surface and tighten the set screws to
secure the glass.
(Fig 6)
7.
Repeat Step #6 to mount the second
Support Bar (#04)
.
(Fig 7)
