“ENIGMA Z” Enclosure Rev.1 Ver.1 05/2013
2
Preparation
1.
After opening all boxes and packages, read this introduction carefully. Check that all of the needed
parts are included in the package by marking all the components on the “Detailed Diagram of
Shower Door Components”. Examine boxes and packages for shipping damage. If the unit has
been damaged, has a finishing defect, or has missing parts, please contact our customer support
department within 5 business days of the delivery date. Please note that
DreamLine
TM
will not
replace any damaged products or missing parts free of charge after 5 business days or if the
product has been installed.
Feel free to contact DreamLine
TM
if you have any questions.
2.
Please note that you should consult your local building codes with questions on installation
compliance standards. Building and plumbing codes may vary by location, and DreamLine is
not responsible for code compliance standards for your project and will not accept any
returns.
3.
Please ensure that prior to the installation the installation surface is leveled and solid and will be
able to support the total weight of the unit. Also make sure the walls are at right angles. Irregular
installation surface level or improper angle of side walls will result in serious problems for your
installation. Please, note that some adjustments and drilling might be necessary during the
installation process.
4.
This unit has to be installed against a finished floor and walls.
5.
Please, NOTE! This door does not have out-of-plumb adjustment. Make sure your walls are
at right angles.
6.
This door requires a minimum 2
3/8” wide threshold, base or installation space.
7.
Please note that Step 6 calls for installation of the door to the wall using anchors.
However, the manufacturer strongly recommends installing these heavy doors to
the studs or to preinstalled 2x6 wood reinforcements behind the wall and attach the
Wall brackets to it.
Attention: This enclosure is extremely heavy and requires
professional installation.
Tools Required
Caulk
Tape
Measure
Pencil
Screwdriver
Phillips
(Ø=3/8")
Drill bit
Level
Gun
Caulk
Drill
Electric
Hammer
Miter saw or Hacksaw
(Ø=1/8")
Drill bit
(Ø=5/16")
Drill bit
