http://dreamcatcher.asia/cw
ME1000 RF Circuit Design
Quick Start Guide - 11/23
4. Quick Setup and Verification
4.1
The following steps demonstrate the setup and verification of the entire system:
Step 1: Installing the RF Trainer Control Panel Software
Step 2: Powering Up the Transmitter Unit and Receiver Unit
Step 3: Verifying the Transmitter Unit
Step 4: Verifying the Receiver Unit
Step 5: Verifying the Final End-To-End System
IMPORTANT
•
The transmitter and receiver units can be damaged by excessive power levels from the
instruments. Please adhere strictly to the power levels recommended in the instructions.
•
Turn off the training kit when not in use.
•
Always ensure that the casing is grounded and the cover is latched before powering up the
device.
Step 1 : Installing the RF Trainer Control Panel Software
•
Run the RF Trainer Control
Panel from the ME1000 CD
provided. Install the Microsoft
.NET Framework when
prompted.
•
Launch two Control Panels by
clicking the RF_Trainer icon on
your desktop twice. One Control
Panel will control the transmitter
unit while the other will control
the receiver unit.
Two Control Panels
1
2
1
2
The N(m)-to-SMA(f) adapters are always
connected to all SMA connectors of the training
kit to prevent the SMA connectors from wearing
out due to regular connection and disconnection
of the SMA cables. If the adapters are worn out,
they can be easily replaced with new ones. This
measure is taken to simplify part replacement
since the SMA connectors of the training kit is
soldered to the PCB board.
