Draytek VigorSwitch P1085, User Manual, Page: 192 / 267

VigorSwitch P1085 User’s Guide 184
 <config-if># lldp tlv-select TLV < port-desc, sys-name, sys-desc,
sys-cap, mac-phy, lag, max-frame-size, management-addr>

<config-if># lldp tlv-select pvid <disable/enable>

<config-if># lldp tlv-select vlan-name <add/remove> <2-4094>

<config-if># lldp <rx/tx>
mac Specify an access control list for packets.
Before configuring, you have to create an ACL based on MAC address.
For example,
<config># mac acl CA_ACL
<config-mac-acl>#
<NAME> - Enter a name for ACL.
Related Syntax:

<config-if># mac acl <NAME>
no Negate command. Such command can disable current setting of
command executed and return to the factory setting of that
command.
Example:
<config-if> # no mvr
The operation will make mvr setting is default. Continue?
[yes/no]:yes
<config-if> #
Related Syntax:

<config-if># no <command>
poe Enable or disable the PoE port.
power Configure the inline power for the PoE device.
inline auto - Turn on the PoE device discovery protocol and apply the
power to the devcie.
inline never - Turn off the PoE device power.
power-limit <15.4w/30w/MW> - Set the power limit for the PoE
device.
priority <1-3/critical/high/low> - Set the priority of power
application for the PoE device.
schedule-index - Specify the index number of the schedule profile.
Related Syntax:

<config-if># power inline auto

<config-if># power inline never

<config-if># power power-limit <15.4w/30w/MW>

<config-if># power priority <1-3/critical/high/low>

<config-if># power schedule-index
protected Configure an interface to be a protected port.
Related Syntax:

<config-if>#protected
qos cos - Configure the default CoS value for an Ethernet port.
<0-7> - Specify a CoS value for the selected interface. Default value
is 0.
remark - Configure remarking state of each port.
trust - Configure each port to trust state while the system is in
“basic” mode. There are four trust types for a device to judge the
appropriate queue of the packets.
<cos> - Enable cos remarking.
<dscp> - Enable DSCP remarking.
<cos-dscp> - Enable cos and DSCP remarking.
<precedence> - Enable IP precedence remarking.