Firewall Setup
6-11
to view the logs.
Direction
Sets the direction of packet flow. For the Call Filter, this setting is
irrelevant.
Keep State and Fragments (for Data Filter only)
These should be accompanied by the below settings also.
IN:
Specify the rule for filtering incoming packets.
OUT:
Specify the rule for filtering outgoing packets.
Protocol:
Specify the protocol(s) this filter rule will apply to.
IP Address:
Specify a source and destination IP address for this filter rule
to apply to. Place the symbol
!
before a particular IP Address will
prevent this rule from being applied to that IP address. It is equal to
the logical NOT operator.
Subnet Mask:
Specify the Subnet Mask for the IP Address column for
this filter rule to apply to.
Operator:
The operator column specifies the port number settings. If
the
Start Port
is empty, the
Start Port
and the
End Port
column will be
ignored. The filter rule will filter out any port number.
=
: If the
End Port
is empty, the filter rule will set the port number to be
the value of the
Start Port
. Otherwise, the port number ranges
between the
Start Port
and the
End Port
(including the
Start Port
and the
End Port
).
!=
: If the
End Port
is empty, the port number is not equal to the value
of the
Start Port.
Otherwise, this port number is not between the
Start Port
and the
End Port
(including the
Start Port
and
End
Port
).
Summary of Contents for Vigor 2200V
