Section 7 -
Electrical Connections
Lift operates on 220V, 60 Hz. current. Lift ships with internal wiring complete and control switch
(es)
fully boxed.
Wire to connect lift to switch
(es)
and switch
(es)
to power supply should be furnished by installer.
Please Note:
Lift must be installed in accordance with requirements of Local Building Codes, Canadian Electrical Code
(CEC)
, CAN/CSA C22.1 and National Electric
Code
(NEC)
, NFPA 70. An appropriate disconnect device shall be provided as part of building installation.
CAUTION:
All operating switches should be "off" before power is connected.
Terminal strip for field connections is located inside a junction box on the end of the unit. Unit ships with internal lift wiring complete to terminal strip. Use switch to lower
lift and remove packing. Remove temporary wiring and complete permanent wiring to electricity and to switches. Wire to connect unit to power supply and to switches
should be furnished by installer. Connections should be made in accordance with wiring diagram. AeroLift 100 / 150 should be operated and checked prior to installing
projector and/or optional ceiling closure.
Section 8 -
Wiring Diagrams
IR Eye Input
Low-Voltage
Trigger
4-28 VDC
RS232/485
Inputs/Outputs
Receiver
Button
3 Button Wall Switch
DOWN - Black
COM - White
UP - Red
Wall Switch
Electrically Straight
Data Cable to more
LVC-IV modules*
* A maximum of six (6)
LVC-IV modules can
be linked together.
FUSE - 3.15 AMP 250 V
AC 5x20mm
Dashed wiring by electrician
Low-voltage wiring by others
Green/Yellow (Ground)
White - Neutral to
LIFT Terminal 6 (Neutral)
Yellow - to LIFT Terminal 4 (Hot)
Black - to LIFT Terminal 4 (Hot)
Brown - to LIFT (DOWN)
Red-to LIFT (UP)
1 2 3 4 5
6 7
8
L1
N
GND
To 220 - 240V
AC Line
Key Operated On-Off
switch (if furnished).
AeroLift Terminal Block
UP
N N
DN COM
LVC-IV - Low Voltage Controller
Single Station Control
To 220-240 Vac Line
Dashed Wiring
By electrician.
LS2
LS1
LS2
LS1
BK
BL
BL
BK
OR
RD
1 2 3 4 5
6 7
8
TB
BK
RD BRN BK BK BL
WH
GN/YL 14 AWG
GN/YL
RD 14 AWG
BK 14 AWG
WH 14 AWG
GN14 AWG
BK 14 AWG
BRN
PROJECTOR
OUTLET
MOTOR
BK
BL
L1
N
GRD
UP DOWN
COMMON
SWITCH
BL 14 AWG
BL
page 6 of 8
AeroLift 100/150 220V
