Section 4 -
Motorized Roller/Fabric Installation
(
Roller and Fabric standardly ship already attached in place for new unit shipments.)
1.
Remove bottom access panel
(See Section 3)
.
2.
Back out the two set screws in bracket until they are flush
with top side of bracket
(See Fig 5)
.
3.
To engage motor end bracket flange
(above the two channels in
the top of the screen housing)
, rotate bracket approximately 45°
counterclockwise to allow top surface
of motor bracket to rest flat against top inside housing.
4.
Rotate bracket clockwise until it engages in channel.
5.
Engage idler end bracket in same manner as motor end bracket
and slide toward opposite end of screen housing.
Caution:
Step 6 requires two people to perform safely.
6.
Locate retaining clips attached to instruction sheet.
Lift roller/fabric assembly into screen housing and engage motor
head completely into motor bracket, making sure limit switch
adjusting knobs are visible from bottom of screen housing
(Fig. 7)
.
Please Note:
If snap ring is provided, make sure it engages with
motor. If retaining clip is provided instead, install to lock motor
end in place.
7.
Support idler end of roller and slide mounting bracket toward
roller. Insert roller pin into nylon bushing on idler bracket
(Fig. 6)
.
8.
Roller idler pin goes through idler bracket. Reinstall washer and
retaining clip.
Caution:
Failure to replace washer and retaining clip could result in separation of roller from brackets.
9.
Center roller/fabric assembly by sliding mounting brackets left or right.
10.
Securely tighten set screws on roller mounting brackets.
11.
Connect electrical plug from motor to mating socket on junction box.
12.
Attach door support brackets.
13.
Reinstall bottom access panel as previously described.
CENTER of CASE
CENTER
of CASE
Engagement Bracket
With Ball Detent:
will snap into Access
Panel Support Bracket.
Access Panel
Support Bracket
1
2
Attaching Brackets:
Insert pin in top
slot and push up.
Rotate bracket
clockwise to lock
bracket in place.
Remove Screws
from both ends
of Housing.
Access
Panel Door:
Pivot on Hinges.
OPEN
ACCESS
PA
NEL
CLOSED
ACCESS P
ANEL
HOUSING
Section 3 -
Bottom Access XL Panel Installation/Removal
Figure 3
Access case as seen from below
Bottom access panel secures to the screen housing
with two screws
(one on each end)
, and held in the closed
position by engagement brackets with ball detents that
snap into case support brackets
(Fig. 3)
.
CAUTION:
The following requires two people to perform safely.
Bottom flange of
Access housing
Bottom Access Panel Door
CAUTION: Beware of pinch points at ends of closure
Figure 4
Removing Access Panel
1.
Press up on access panel and pull toward the front of the
screen housing to disengage hinges and remove access panel.
2.
To Remove/Install support brackets:
SIDE VIEW
SIDE VIEW
BOTTOM VIEW
BOTTOM VIEW
MOTOR END OF CASE
IDLER END OF CASE
Motor End
Retaining Clip
Set Screws
Motor End
Mounting
Bracket
Idler End
Mounting
Bracket
Idler End
Retaining
Clip
Figure 6
Figure 7
Figure 5
page 4 of 8
Access XL E and V 220V
