Do not sand workpieces shorter than 70mm or thinner than 1mm.
Properly support long or wide workpieces.
Disconnect the machine from the power source before installing or removing accessories, before
adjusting or changing set-ups, or when repairing.
Disconnect the machine from the power source and clean the table/work area before leaving the
machine. Lock the switch in the ‘OFF’ position to prevent unauthorised use.
The belt linisher is mainly used to conduct surface polishing and grinding of metal, so as to
enhance the roughness and glossiness of spare parts surface. It enjoys high efficiency and
superior performance in grinding. It is an ideal substitute for polishing machines.
This machine is only used for general metals grinding within the range of grinding capacity. Metals
with low ignition points such as magnesium, etc., are prohibited to be machined.
5.3 RESIDUAL RISK
Important: Although the safety instructions and operating manuals for our tools contain extensive
instructions of safe working with power tools, every power tool involves a certain residual risk
which can not be completely excluded by safety mechanisms. Power tools must therefore always
be operated with caution!
5.4 CONNECTION TO THE POWER SUPPLY
Caution: Risk of electric shock. Do not open.
This appliance is supplied with a moulded 3 pin mains plug for your safety. The value of the fuse
fitted is marked on the pin face of the plug. Should the fuse need replacing, ensure the substitute
is of the correct rating, approved to BS1362 and ASTA or BS Kite marked.
ASTA
BSI
The fuse cover is removable with a small plain slot screwdriver. Ensure the fuse cover is replaced
before attempting to connect the plug to an electrical outlet. If the cover is missing, a replacement
must be obtained or the plug replaced with a suitable type.
If a replacement plug is to be fitted this must be carried out by a qualified electrician.
The damaged or incomplete plug, when cut from the cable should be disabled to prevent
connection to a live electrical outlet.
This appliance is Class I
†
and is designed for connection to a power supply matching that detailed
on the rating label and compatible with the plug fitted.
If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow all the instructions supplied with the extension lead.
†
Earthed : This product requires an earth connection to protect against electric shock from
accessible conductive parts in the event of failure if the basic insulation.
Important: On products exceeding 2000W it is recommended that the power cable and/or
extension cable are fully unwound before a connection is made to the power supply.
However, ensure the residual cable does not pose a trip hazard.
– 9 –
5. HEALTH AND SAFETY INFORMATION
