EN
EN
7. Assembly Instructions
7. Assembly Instructions
5
Fig.
8
Fig.
9
Fig.
10
Fig.
11
Fig.
12
Fig.
7
Fig.
6
Fig.
7.3 Attach the Crossbars
7.4 Attach the U-Brackets to the Top Frames
1. Insert the front
left leg (A) between the left brackets
of the front crossbar (E) so that the holes align.
Important: The crossbar brackets can be shaped
to fit comfortably around the leg as required.
2. Pass two M6 x 37mm half-thread screws (O) through
the front crossbar brackets around the front left leg
and secure each in place with an M6 washer (R) and
an M6 nylon-insert lock nut (T).
3. Insert the front right leg (B) between the
right
brackets of the front crossbar so that the holes align.
4. Pass two M6 x 37mm half-thread screws (O) through
the front crossbar brackets around the front right leg
and secure each in place with an M6 washer (R) and
an M6 nylon-insert lock nut (T).
5. Place the rear crossbar (F) between the rear legs and
align the holes.
6. Secure the rear crossbar in place using four
M6 x 37mm half-thread screws (O), M6 washers (R)
and M6 nylon-insert lock nuts (T).
Important: Once assembled, the legs should bend
outwards slightly at the bottom to improve the
stability of the workbench.
1. Remove the two screws near the crank handle (2) in
the left top frame.
2. With the bracket arms extended upwards, align
a bare U-bracket (J) with the holes and screw it
into place.
5. Slide the guide plate under the top of the top frame
and pass the screw down through the U-bracket to
secure it into place.place.
6. Replace the M10 nut above the U-bracket.
Important: DO NOT overtighten the guide plate
screw or M10 nut as this will stop the crank handle
from operating smoothly.
7. Repeat these steps for the right top frame.
3. Unscrew the M10 nut (9) from the left top frame and
unscrew the plate from a U-bracket with guide plate
(K).
4. Place the centre hole of the U-bracket over the M10
bolt in the top frame so that the bracket arms extend
upwards and the two smaller holes are positioned
above the slot.
– 10 –
– 11 –
(9)
(J)
(E)
(A)
(K)
(I)
(2)
