22
16. MAINTENANCE – ATTACHMENTS
14.5 REWINDING THE SPOOL INSERT
(FIGS 22 – 24)
– With the engine stopped, squeeze [with equal
pressure] both sides of the spool housing
at
points to release the spool cover.
Note:
Behind the spool insert is a large spring with
two large washers. Take care that these do not spring
out or get lost. On the back of the spool insert is
marked the direction or rotation.
– Find the middle of the replacement nylon line and
hook this in to the spool insert at point
.
– Wind the nylon line neatly in both channels of the
insert in the indicated direction.
– When both the lines are wound, hook them
through the insert at points
to hold them in
place. Leave a short piece of nylon to feed out
through the spool housing.
– Place the large washer, spring and large washer in
the spool housing as shown.
– Feed the nylon ends out through the spool
housing.
– Carefully lower the spool insert down over the
washer and spring while pulling the nylon end
tight. When everything is lined up push down on
the insert at the same time pulling the nylon ends
free from the insert. Watch that nothing becomes
trapped while you do this.
– While keeping the insert pressed hard down on to
the spring, replace the spool cover and clip it back
down.
FIG.22
FIG.23
FIG.24
