Dramm Turbo ULV Manual Supplement 9/18
Mixing Instructions:
The Turbo ULV requires the use of a carrier solution for best application. The carrier solution helps to
produce a more even sized droplet, preventing very large droplets from forming.
While some chemicals may include fogging adjuvants, most do not. Check with your chemical
manufacturer regarding this.
Dramm sells three different carrier solutions for the pulsFOG: VK-I, VK-II and NutriFOG.
VK-I
Use with EC chemicals only
VK-II
Use with all formulations of chemical
NutriFOG
Use with all formulations of chemical
VK-I
requires no water for mixing. Mix the correct quantity (see accompanying chart) of EC chemical
directly into 1 liter of VK-I to treat 10,000 square feet.
NOTE: Do not apply VK-I over wet crops. Leaves should be dry during the application
.
VK-II
is mixed with water. Mix the correct quantity (see accompanying chart) of chemical with 0.5L of
VK-II and 1.5 L of water to treat 10,000 square feet.
NOTE: VK-II can damage certain crops, especially when in bloom. Take care when using,
especially later in the season.
NutriFOG
is mixed with water. Mix the correct quantity (see chart) of chemical with 0.25 L of
NutriFOG and 1.75 L of water to treat 10,000 square feet.
NOTE: Do not apply more that 1.5 L of NutriFOG to the same 10,000 square foot area in ONE
MONTH.
While these carrier solutions have been used with most greenhouse chemicals without incident, it is
always advisable to perform a jar test with the proper ratios of chemical, carrier, and water to ensure
compatibility with any chemical you are not certain of.
