Dramm Turbo ULV Manual Supplement 9/18
NOTE ABOUT MIXING THICK CHEMICAL SOLUTIONS:
Depending on the type or volume of chemical product you are using, the solution may be too thick to
apply without clogging. If the product does not seem dilute enough to apply correctly, it is advisable
to add carrier and water in the correct ratio until the product is dissolved well enough to be applied
as a fog.
Always adjust the fogging time to ensure that the appropriate amount of chemical active ingredient is
applied to the area you are treating.
Cleaning Your Turbo ULV
To keep your PulsFOG running well, cleaning is essential. Most maintenance issues we service are a
result of poor cleaning and care.
After use, remove tank and triple-rinse. Fill with 0.5 Liters of warm water and fog through the
machine to clean out the solution lines.
After five hours of use, inspect the air filters in the rear of the housing for wear or clogging. Replace if
necessary.
The primary filter may be washed with water. ENSURE FILTER IS DRY BEFORE REPLACEMENT.The
secondary filter may be blown clean with compressed air.
Notes:
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
Dramm Corporation
920/684.0227
www.dramm.com
