Dragon Wholesaling LF750, User Manual

Page: 11 / 48

Manual
V 1.7
Page 10 of 47
WARNING
Do not use or attempt to start the lifter
without the protective guarding in place.
Failure to do so may result in personal
injury or loss of life.
Starting the Machine
Checks Before Starting

Ensure the machine is located on firm flat ground.

Check all guards are fitted.

Carefully inspect tracks for cuts or other damage.

Visually check for fluid leaks.

Ensure there is sufficient fuel in the fuel tank.

Ensure that all track levers are in the neutral
position.

Ensure E-Stop buttons are pulled out.
Figure 3: Engine Parts and Controls
Starting Procedure
Do not place engine under full load at full speed immediately after starting. Always allow the engine
to fully circulate lubricant and warm up gradually before operating at full speed and load.

Move throttle lever in direction of (BLUE arrow) to the half-way position.

Pull choke control to the full choke position in direction of BLUE arrow.

Insert key into the ignition.

Turn the key clockwise to turn ON the machine, the engine will crank over.

Release the key as soon as the engine starts.

Push the choke control to the off position soon after starting. Normally with 1-2 seconds

Allow the engine to warm up.
NOTE: To extend the life of the starter motor, use only short starting cycles - 5 seconds max.
Cap – Fuel Tank
Fuel Tank
Dip Stick
(Oil Level)
Oil Fill
(Below Exhaust)
Machine Start
Pull Cord
(Hand Start)
Choke Lever
(Bottom)
Throttle / OFF
Lever (Top)
Air Cleaner
Exhaust Muffler
Oil Drain