DR RAPID-FEED 16.50 PRO, Safety & Operating Instructions Manual

Page: 31 / 80

CONTACT US AT
www.DRpower.com
Adjusting the Angle of the Tongue Weldment
The Tongue Weldment can be adjusted to the horizontal
position to enable the Chipper to be towed with a tractor or
it can be adjusted to the vertical position as a Support Leg
to level and stabilize the Chipper when not hitched to a
Tongue Weldment so it can rotate freely).
2. Pull the Hitch Clip from the Pin and remove the Pin
leg) position and reinsert the Pin into the Pin Holes for
4. Secure the Pin by inserting the Hitch Clip.
5. Reverse these procedures to Adjust to the Towing
tractor.
1. Support the front of the Base Frame with a Jack Stand
or Blocks (make sure you are off to the side of the
Pin Holes for
Towing Position
Pivot
Tongue
Weldment
Pin Holes for
Support Leg
Position
Support Leg
Position
Towing
Position
Pin and
Hitch Clip
( Figure 22 ).
3. Rotate the Tongue Weldment to the vertical (support
the Support Leg position.
Figure 22
position (non-highway) and your Chipper is now ready
to hitch to your tractor.
AVOID DEATH OR SERIOUS INJURY. DO NOT TOW THIS MACHINE FASTER THAN 10 MPH. THIS
MACHINE IS NOT LEGAL FOR STREET OR HIGHWAY USE UNLESS YOU INSTALL THE ROAD-
TOWING PACKAGE (SEE “CHIPPER ACCESSORIES” IN CHAPTER 7).
or CALL TOLL FREE
1-800-DR-OWNER
27