Dr.X Works G1-ISOK, Product Manual

Page: 39 / 62

1-2
１－３ Unpacking the POWER SUPPLY
When unpacked the unit, you will please check the following accessories are enclosed with power supply
main body.
〈ACCESSORIES〉
・ AC input cord (1 pc.)
・ Instruction manual
・ Output cable
・ Interface(TB1) D-sub connector(1 pc.)＊Installed on rear panel(TB1)
〈Initial Checking〉
・Check the panel and chassis for any apparent trace of impact such as a dent.
If any failure is found, contact the carrier and the manufacturer
.
１－４ Installation conditions
1-4-1 Safety
Warning
This unit is a high voltage power supply. Observe the safety precautions and operate correctly,
or an electric shock or a fatal accident may be caused.
Observe the following precautions in operation and inspection this power supply to operate and
handle it correctly.
・Install the power supply unit horizontally for use.
・The top and side surfaces are the cooling air supply and exhaust openings. The power supply must be
arranged with adequate space and good ventilation.
・Do not put any object on the power supply unit.
・Do not operate the power supply in a dusty area or in corrosive gas environment.
・Do not use any substitute for the parts in the internal circuits or do not modify them without
permission.
・This power supply is designed to a 19 inch rack. The chassis should be supported by the guide in
mounting. Never support it with the front panel mounting hole only.
・The front panel handle is used to change the direction of the power supply or pull out the power supply
mounted onto the rack. Do not use the handle with bearing the whole weight of the power supply on
the handle.
・Carefully handle the power supply with giving no impact in carrying. It is dangerous for a person to
carry the power supply (80kV-120kV) alone due to the heavy weight of approx. 20kgs. Two persons or
more should hold to carry or a cart should be used to carry.
・ Contact us for repair. The power supply should be repaired by us.
1-4-2 Connecting AC line input cord
・Plug the enclosed AC line input cord to the rear panel AC line input connector. For safety, use the
cable fixing vinyl clamp to fix the cord. (Fig.1.1)
・The AC100V is different from the AC200V in the type of the included AC line input cord. For AC100V,
a commercial outlet can be used. For AC200V, attach a crimp style terminal to the cord end and
connect to the commercial power board.
！
NO
！

MUST
！

CAUTION
！

MUST
NO
NO
NO
NO
NO
１ I n t r o d u c t i o n