DR Power Mow Pro-44, Safety & Operating Instructions Manual

Page: 11 / 44

CONTACT US AT
www.DRpower.com
11
The Mow Pro-44 Model is shipped mostly assembled. Go to “Installing the
Discharge Guard” section if you have a Mow Pro-44 Model.
Tools and Supplies Needed:

Wire Cutters

Two 3/4" Wrenches

7/8" Socket with Torque Wrench

1-1/16" Wrench*

5/16" Wrench

Blocking
*or Adjustable Wrench
Assembling the Deck to the Frame (Mow Pro-60 Model only)
1. Leave the Deck Bushings in place as you remove the Bolt and Locknut (by
hand) that secures the two side Sway Braces to the Deck (
Figure 5 ).
2. Leave the Deck Bushing in place as you remove the Bolt and Locknut (by
hand) that secures the front Sway Brace to the Deck (
Figure 6 ).
3. Remove the remaining Bolts and Locknuts from the three Sway Braces.
4. Remove the three Nuts, Hand Crank and Height Adjust Block from both
threaded Rods (
Figure 7 ).
5. Position the two Threaded Rods so they are vertical.
6. Place the Frame Assembly as shown with the Caster Wheels next to the back
of the Deck Assembly. Turn the Casters toward the rear wheels (
Figure 8 ).
7. With the help of another person, position the Frame over the Deck
Assembly with the Threaded Rods through the slots in the Frame (
Figure 9 ).
Note: We recommend adding Blocking at both sides of the Pallet to help stabilize
the Wheels ( Figure 10 ).
Frame
Assembly
Figure 8
Deck
Assembly
Front
Front
Threaded
Rod
Slot
Caster
Turned
this way
Caster Turned
towards Rear
Figure 10
Blocking
Hand Crank
Figure 7
Nuts
Height
Adjust Block
Threaded
Rod
Sway Brace
Figure 5
Bolt and
Locknut
Bushing
Sway Brace
Figure 6
Bolt and
Locknut
Bushing
Threaded
Rod
Figure 9
Slot in
Frame