DR Power Mow Pro-44, Safety & Operating Instructions Manual

Page: 13 / 44

CONTACT US AT
www.DRpower.com
13
Installing the Discharge Guard
1. Install the Discharge Guard with five 3/8-16 X .75" Bolts using a 9/16"
Wrench (
Figure 17 ).
Note: If it is difficult to install the Bolt at the front (Mow Pro-60 Model) the Anti-
scalping Wheel can removed using a 9/16" Wrench and Adjustable Wrench
to make it easier.
Attaching the Tow Bar to the Push Bar
The Tow Bar can be installed for offsetting to the right or left depending on
which side of the Tow Vehicle you choose to mow. See section “Offset
Mowing” in Chapter 3 to determine how the Tow Bar should be installed for
your needs. The following steps describe positioning the Offset Bracket to
allow offset to the right side of the Tow Vehicle.
1. Secure the Offset Bracket to the Push Bar in the configuration shown (for
right side offset) using the 4.5" long Clevis Pin, Washer, and Hair Pin
(
Figure 18
).
2. Align the Tow Bar so it is pointed straight out from the Mower and install a
Clevis Pin, Washer, and Hair Pin in the Offset Bracket to lock the Tow Bar in
position.
3. Align the Tow Bar Extension with the Tow Bar and install a Clevis Pin,
Washer, and Hair Pin in the Tow Bar to lock the Tow Bar Extension in place
(
Figure 19 ).
4. Raise the Deck (see “Adjusting the Mower Deck Height” in Chapter 3) and
with a helper, roll machine backwards off Pallet. You May need to use a bar
to lift deck over the Blocks if it gets hung up.
Offset
Bracket
Figure 18
Push Bar
Clevis
Pin
Hair Pin
Washer
Clevis Pin
and Hair Pin
Washer
Tow Bar
Discharge
Guard
Figure 17
Bolts
Figure 19
Tow Bar
Extension
Washer
Clevis Pin
and Hair Pin
Tow Bar
Always install the Clevis Pins from the bottom with the Washers and Hair Pins
on top to prevent the Hair Pin from being pulled out by tall grass or bushes.