DR Power Mow Pro-44, Safety & Operating Instructions Manual

Page: 15 / 44

CONTACT US AT
www.DRpower.com
15
Connecting the TOW-BEHIND DR FIELD and FINISH MOWER to your Tow Vehicle
The Pin type Hitch that comes standard on the TOW-BEHIND DR FIELD and FINISH MOWER Tow Bar is quick and easy to attach
to Tow Vehicles with a hole in the Hitch Plate. A ball Hitch Kit is also available if you would prefer attachment to a 2" Ball on the
Tow vehicle. Visit our website at www.DRpower.com to order Ball Hitch Kit #36578.
1. Move your Tow Vehicle to a flat area and set the Parking Brake.
2. Align the Tow Hitch to the tow vehicle Hitch Plate with the top portion of the
Tow Hitch above the Hitch Plate and the bottom portion below (
Figure 23 ).
3. Secure the Hitch with the Clevis Pin and Hair Pin.
Checking the Tire Pressure
Tools Needed:

Tire Pressure Gauge

Air Compressor
1. Remove the Valve Stem Protective Cap ( Figure 24 ) and check the tire pressure
with a Tire Pressure Gauge.
Note: Figure 24 shows the fixed rear Wheels. Use the same procedure for the front
Caster Wheels.
2. Compare the tire pressure reading from with the manufacturer's
recommended tire pressure stamped on the side of the tire.
3. If the pressure is too low, add air through the Valve Stem with an air hose.
4. Replace the Valve Stem Protective Cap when finished.
Valve Stem
Protective Cap
Figure 24
Clevis Pin and
Hair Pin
Figure 23
Washer
Tow Hitch
Tow Vehicle
Hitch Plate
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.