16
DR
®
9.5 Chipper Shredder
Using the Collection Bag
An optional Collection Bag is provided with your machine.
1.
Install the open end of the Collection Bag over the rubber Discharge
Deflector and hook it onto the metal housing tabs above and below the
Discharge Deflector (Figure 19).
2.
Squeeze the Rope Lock and pull the Rope to cinch the Collection Bag tightly
around the housing tabs then release the Rope Lock (Figure 20).
Note:
Chip and shred as normal. Make sure to empty the Collection Bag before it is
completely full.
To Free a Clog
1.
Remove any material left in the Chipper Chute and Shredder Hopper with a
wooden stick.
2.
Check the Discharge Opening for clogs. If it is clogged, clear it with a stick.
3.
Start the machine and allow any remaining material to discharge.
4.
If you have been shredding wet/green materials the clog may be near the
shredder housing inlet. Shred a wood stick of up to 1" diameter to clear the
clogged wet material.
5.
If the clog does not clear repeat the above process.
6.
Be certain the cutting chamber is clear before trying to process more
material.
Collection
Bag
Figure 20
Rope Lock
Rope
Before performing any maintenance procedure or inspection, stop the
Engine, wait five (5) minutes to allow all parts to cool. Disconnect the
Spark Plug Wire, keeping it away from the Spark Plug.
Discharge
Deflector
Figure 19
Tab
Tab
