10
GB
Now let the installation plate (24) drop down
over the upper bearing, and tighten the two
nuts (26) fi rmly (Fig. 18).
Fig. 18
7. Electrical connection of the ele-
ments
All 3 elements have their electrical connec-
tions at the top, and are connected to the
control unit (29) by means of the 3 plugs (30
- 32) (Fig. 19).
Fig. 19
29 = Control unit
30 = Connection cable, right element
31 = Connection cable, left element
32 = Connection cable, door element
35 = Main connection cable
8. Installing the upper trim panels
Finally, fi t the three trim panels (33) around
the upper edge of the system (Fig. 20), using
for each panel two self-tapping screws (34)
on the outside, and two M4 screws in the
central area.
Ensure that a distance sleeve is placed bet-
ween the trim panel and rear wall of the unit
at each attachment point.
Fig. 20
9. Installation of main connection ca-
ble / cover panel
The main connection cable (35) is pre-as-
sembled to the control unit (29), and lies
rolled up on the exhaust unit.
Take the cable (35) and lead it down along
the side of the system (Fig. 21).
Now remove the cover panel (37) from pa-
ckage 3, and fi t it as shown in Fig. 22.
Note:
The existing screws in the rear
walls are used for the attachment of
the cover panel (37). These screws
must be removed before fi tting the co-
ver panel.
25
24
26
27
28
29
30
31
32
35
33
34