EN
19
The pressure does not
rise although the pump is run-
ning.
Check the connection of the cuff
tube and connect properly.
The device frequently fails to
measure, or the values mea-
sured are too low or high.
1. Fit the cuff correctly on the arm.
2. Before starting measurement
make sure that clothing is not
exerting pressure on the arm.
Take articles of clothing off if
necessary. Measure blood pres-
sure again in complete peace
and quiet.
Every measurement results
in different values, although the
device functions normally and
normal values are displayed.
1. Please re-read the points listed
under “Measuring procedure”.
2. Blood pressure changes con-
stantly. The observed readings
may accurately reflect your
pressure - minor differences in
the readings are not abnormal.
Blood pressure values
differ from those measured
at the doctor’s.
Record daily values and consult
your doctor.
Pressure readings in the doc-
tor’s office may be higher due to
anxiety.
After the instrument has inflated
the cuff the pressure falls very
slowly, or not at all.
Check cuff connections.
ATTENTION
Should any technical malfunctions arise in the blood pressure monitor,
please contact the the authorized service centre of
Dr. Frei
®
.
never
note:
Blood pressure is subject to fluctuations even in healthy people.
Please remember that comparable blood pressure measurements always
require the same time and the same conditions! These are normally quiet
conditions. If you follow the correct procedures described above and still
get the fluctuations of blood pressure of more than 15 mmHg and/or you
repeatedly hear irregular pulse tones please consult your doctor.
Summary of Contents for M-100A
Page 2: ......
