DPS Telecom D-PK-NGAAR, User Manual, Page: 37 / 80

33
Serial Port 10.4
The Provisioning > Serial Port menu allows you to change settings depending on the port type of your
NetGuardian AAR. From this menu, you can select a mode of operation and enable reach-through serial port
functionality.
The Provisioning > Serial Ports menu
Location
A reminder that your primary serial port is located on the back of the NetGuardian AAR
chassis.
Port Configuration
Port Type
Select the serial port for your build of the NetGuardian AAR.
Choose from 232, 485...
Baud, Parity, and Stop Bits Select the appropriate settings from the drop-down menu.
RTS Head
Only used if your NetGuardian AAR was built with a 202
modem. The most commonly used value is 30.
RTS Tail
Only used if your NetGuardian AAR was built with a 202
modem. The most commonly used value is 10.
Reach-Through
Enable Reach-through
Checking this box enables the port to be used as a terminal
server. Most commonly used to Telnet through the port over
LAN to a hub, switch, or router. From a command prompt,
type the following
(note the spaces between each entry) :
telnet [IP address] [port]
Example : telnet 192.168.1.100 3000
Port Port number used for reach-through to a serial device.
Type
Select TCP or UDP traffic to be passed through to a serial
device.