AEF-A.DOC
11/2011
18
CHAPTER 6
THIS SECTION NEEDS TO DONE BY A QUALIFIED
TECHNICIAN.
6.1 – EVERY 6 MONTHS
6.1.2 – CONTROL OF BELT’S STRETCHING
It is necessary to control the belts’ stretching every 6 months in all transmissions. If the belts
are too loose, the machine will lose power.
a)
The transmission’s belts of the spiral can be examined by opening the cover of the
machine.
b)
The transmission’s belts of the bowl can be examined by removing the access panel on
the bottom side of the machine.
c)
To verify if the belt needs to be stretched, press a finger in the middle of the belt, and if
the looseness is superior to ½" (1 cm), there is a need to stretch it.
d)
To stretch it, it is necessary to call an authorised technician.
6.1.3 – SAFETY INSTRUCTIONS
•
The machine must be used only for the functions that it has been conceived for. Doyon
Equipment will not be responsible for the damages caused by an improper, bad or irrational
use of the machine.
•
Before cleaning or doing maintenance, turn the main switch off and unplug it.
•
Do not remove security parts of the machine.
•
If the machine has inactive security units, do not turn it on.
•
The work of the machine may be stopped by using the red stop switch.
•
If you detect any damages or bad functions of the machine, turn it off immediately and call
for an authorised technician, otherwise it may cause irreversible damages in the machine.
•
The electric connection must follow the procedures presented in the installation chapter.
6.1.3 – CAUTION
CAUTION
The spiral (point 4, fig.2) in movement is the most dangerous part of the machine.
The safety guard does not allow the access to this area (point 3, fig.2). You must not remove it,
damage it or modify it.
CAUTION
Danger, the transmission must be protected with fixed protections. In order to have access to
them, you must respect the instructions of the manual.
