Appliance features
The TAI M appliance can be used to burn wood,
coal (anthracite) and brown coal briquettes. The
appliance comes with a side filling door and coal
bunker.
The TAI C appliance can be used to burn coal
(anthracite) for continuous use. The appliance is
equipped with a coal bunker as standard.
The appliance can be connected to the chimney at
the rear.
The appliance comes with a “cold hand” to manip-
ulate the riddling grate (TAI M), to open the filling lid
and to remove the ash pan.
The multi-fuel appliance (TAI M) is equipped with a
separate door for adding the fuel, the ‘side filling
door’.
The coal bunker can easily be removed via the
filling lid.
The TAI M appliance is equipped with a riddling
grate.
The TAI C appliance is equipped with a fixed burn-
ing grate.
The appliance has two access ports for ash
removal.
The appliance is equipped with an adjustable ther-
mostat.
The appliance is equipped with chamotte or refract-
ory stone interior cladding.
Installation
Preparation
Please check the appliance immediately after deliv-
ery for damage during transport or any other dam-
age or defects. The appliance is attached to the
pallet with screws at the bottom.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, ash pan, grates, bunker and filling lid) from
the appliance before installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
Chamotte inner plates are ochrous on delivery.
They insulate the combustion chamber to
improve the combustion, and they can with-
stand burning anthracite.
Preparing the connection to
the flue
You can connect the appliance to the chimney at the
rear.
Installing and connecting
1. Position the appliance in the correct place, and
make sure it is level.
2. Connect the appliance to the flue hermetically.
3. Re-position all removed parts in the correct places
in the appliance.
Never use the appliance without the fire-res-
istant inner plates.
If it is found that there is inadequate draw, the
recuperator plate at the back of the appliance
can be moved to reduce the dampening. See
next figure.
Subject to change because of technical improvements
15
Summary of Contents for TAI 45C
Page 65: ......
