T
RITON
S
YSTEMS
9640-
TO
-9600
C
ONVERSION
P
ROCEDURE
10
9.
Slide the dispenser into the cabinet while viewing the
dispenser cables. Ensure the cables don’t catch on
anything.
10. Load the currency cassette, prime it and then install
it into the dispensing mechanism. Refer to the 9600
Operations Manual (07103-00032) for instructions
on loading the cassette!
11. After installing the cassette, push the slide tray into
the cabinet and close the security cabinet door.
Check that the dispenser currency exit and the bill
tray opening align. Close and lock the security
cabinet.
12. Plug the ATM main power cord back into the wall
outlet and turn the power on at the service panel, if
needed. Turn the ATM power switch to ON (I).
8.
Lift the dispenser slightly and slide the bottom rear
edge of the unit under the two tabs on the slide tray.
Lower the front of the dispenser, making sure the
cutouts in the left and right chassis extensions hook
the two threaded bolts that are built in to the top front
of the slide tray. The dispenser should lay flush with
the surface of the slide tray.
Place the two included wing nuts on the threaded
bolts and secure the dispenser to the slide tray.
Hook chassis cutouts on slide tray bolts
Secure left and right corners of
dispenser to slide tray using included
wing nuts.
Slide bottom rear edge of dispensing
mechanism under tabs on slide tray.
Refer to the 9600 Operations Manual for additional
information regarding the software setup of the unit.
For additional help, contact the Triton Technical
Service Department.
