Fig. 3 Horizontal base bracket
Fig. 4 Domino bracket
BOLT
DOMINO
C A U T I O N
Installation of 3rd-party materials may result in
diminished case performance.
▲
between the wall and back of case. Using a “J” bar, raise
the end of the case (under cross support), and lower the
vertical support on to the shim packs. Repeat on the other
end of the case.
W A R N I N G
Be certain that your hands and feet are out of
the way before lowering the case. Failure to do
so may result in serious injury.
▲
2.
Once the case is properly placed on the shim packs,
check the vertical plumb of the case by placing a bubble
level on the rear wall. Add/remove shim packs as needed.
For the horizontal level, repeat this process after placing
the bubble level on the front sill.
3.
Bolt the base brackets to the bottom outside-front and
back of both line-up cases (Fig. 3). Repeat this with the
domino brackets to the top of the cases ensuring that
brackets are fastened to both cases securely (Fig. 4).
4.
Properly align the front panels as needed, then install, if
applicable, front panel trim (supplied).
5.
Install the bumper, if applicable, into pre-attached bumper
track and snap into place.
6.
After suffi cient time has passed to allow for bumper
shrinkage, cut away the excess bumper for fi nal fi t and fi n-
ish. Be certain to use an appropriate cutting tool (tubing-
or PVC-cutter) to ensure a smooth cut.
7.
Install case shelves and reconnect lights. Be aware that
differing shelf confi gurations will affect energy consump-
tion and case performance.
8.
Snap toekick back onto the base of case.
CASE INSTALLATION
8
